W-BUS Modul
code: | 5025-000 |
Manufacturer: | DANHAG |
Price with VAT : | 234,70 EUR |
Price without VAT : | 194,00 EUR |
VAT: | 21 % |
availability: | unavailable |
With our w-bus converter, you can switch almost every data-bus controlled heater (CAN-Bus, W-Bus, E-Bus) with a simple +12v signal. This allowes you to use an existing auxiliary heater as parking heater or older remote controls with newer heaters.
Already successfully tested with the following auxiliary- and parking heaters:
To use an existing auxiliary heater as parking heater, just connect the w-bus converter to the w-bus pin of the heater and select the proper data protocol.
Please refer to the rubrik "Auxiliary heater upgrade" where you will find further information.
You can upgarde the auxiliary heater using our APP-control W-BUS or the W-BUS converter. If you just want to switch on the heater by a simple switch, the W-BUS converter will be the right choice.
You can select a switch-on delay for output 2 and the IPCU-signal to activate the heater blower 5 minutes after the heater has been started.
Some heater have limited the maximum heating time to about 255 minutes internally. If you select "start repetition", the W-BUS converter will switch off the heater after about 55 minutes and restarts the heater again.
Installation by a professional service dealing with the installation or repair of independent heaters is recommended.
Price without VAT: | 97,90 EUR |
Price with VAT | 118,40 EUR |
Price without VAT: | 272,30 EUR |
Price with VAT | 329,50 EUR |
Price without VAT: | 109,10 EUR |
Price with VAT | 132,10 EUR |
Price without VAT: | 342,20 EUR |
Price with VAT | 414,00 EUR |